Quick installation and removal tutorial for electrostatic film

In the pursuit of home aesthetics and practicality, electrostatic film, as a convenient and environmentally friendly decorative material, is deeply loved by consumers. It can not only effectively protect the wall, but also change the style according to personal preferences at any time, adding a touch of brightness to the home environment. Today, we will explain in detail the quick installation and removal methods of electrostatic films, making your home decoration more comfortable. Specially recommended is the original wallpaper, factory direct sales, located on the second floor of Gate 91 in Zone 4 of Yiwu International Trade City, with reliable quality.

1、 Quick installation steps for electrostatic film

Prepare tools and materials: static film, ruler, art knife (or scissors), scraper (can be replaced with bank card), clean cloth.

Clean the wall: Ensure that the wall is clean, dry, free of dust and oil stains. Wipe the wall with a clean cloth to remove all impurities that may affect the bonding effect.

Measurement cutting: According to the wall size, use a ruler to measure the length and width of the required electrostatic film, and cut it to the appropriate size with an art knife. Pay attention to reserving appropriate edges for subsequent adjustments.

Tear off positioning: Gently tear off a corner of the protective paper on the back of the electrostatic film, taking care not to touch the adhesive surface with your fingers. Stick one corner of the electrostatic film to the designated position on the wall first, then slowly unfold it, and use a scraper to scrape it flat from the center to the surrounding area to remove any bubbles.

Detail processing: For corners or special shaped areas, a craft knife can be used for fine cutting to ensure a tight fit and no wrinkles.

Inspection and acceptance: After installation, carefully check whether the electrostatic film is flat, without bubbles or wrinkles. If necessary, gently adjust with a scraper.

2、 Quick removal method of electrostatic film

Preparation tools: hot air gun (or hair dryer), scraper.

Heating softening: Use a hot air gun or hair dryer to heat the electrostatic film and soften the adhesive layer on its back. Pay attention to maintaining an appropriate distance to avoid overheating and damaging the wall.

Slowly peel off: After the adhesive layer softens, start from one corner of the electrostatic film and slowly and evenly peel off. If there is significant resistance, the area can be reheated.

Cleaning residues: Use a damp cloth or alcohol swab to wipe the wall and remove any remaining adhesive stains. For stubborn adhesive marks, a suitable amount of adhesive remover can be used to assist in cleaning.

Inspect the wall: After removal, check for any damage or stains on the wall and promptly address them.